CR-10S PRO Fan Duct Optimized

Hi everyone,

This is new optimized fan duct for Creality CR-10S PRO 3D printer ... You better print it using ABS or PETG. Support is needed as shown in the image above .. I advice you to print it will 100% infill and 0.2 layer height.

There are 2 versions: long one and the short one (V2) ... You need to use a longer screw to mount this fan duct (20 mm long will be good) ... Be careful not to break the fragile fan.

Try it., and please let me know if you notice any improvement in your res