Thingiverse
Wet Palette - For Sta-Wet Sponge/Sheets
by ikonis
33
Downloads
19
Likes
0
Makes
I liked the wet palette here: https://www.thingiverse.com/thing:3517666
But I wanted to use my sta-wet sponge and sheets that I already had.
So I took out the bottom pattern, resized it, and made a new shell to house it.
I also went ahead and chopped it in half for printing on my Ender 3 bed.
If you decide to go that route, I suggest printing in ABS so that you can use acetone/plastic cement to get a watertight seal between the two halves.
Generally, I'd think this thing should be
But I wanted to use my sta-wet sponge and sheets that I already had.
So I took out the bottom pattern, resized it, and made a new shell to house it.
I also went ahead and chopped it in half for printing on my Ender 3 bed.
If you decide to go that route, I suggest printing in ABS so that you can use acetone/plastic cement to get a watertight seal between the two halves.
Generally, I'd think this thing should be
Sign in to leave a comment
Sign in