37mm reloading tools/dies

some simple and not exactly necessary but very handy tools/reloading dies for 37mm flares using 209 primers and are 3 inches or shorter.
these are designed to be used either in a bench vise, with a hammer, or by hand if you're strong enough.

instructions:
these are super simple to print, but need to be made somewhat strong, should be at least 150 grams of pla+.
hardware needed is a a threaded rod or really long bolt that's 3-5 mm wide and about 100mm long, two big washers, and three nuts that fit your rod/bolt.

there's five parts, the decapping die for popping out primers, the primer remover plate, primer starter, primer seater and case mouth protector.
assembling the decapping die: thread two nuts a short ways down one end of the rod, tighten together so they don't come loose, place washer on top of nuts, slip inside of die, place next washer on top, then tighten final nut on top. the rod should stick about 15mm out of the bottom of the die.

using them is super self explanatory.
ta