Ender 3 dual lead screw mod

THIS MOD IS INTENDED TO USE A SKR 1.3 WITH 5 STEPPER DRIVERS.
IF YOU WANT TO SO THIS WITH THE STANDARD BOARD THEN YOU WILL NEED TO MODULE LISTED BELOW.
Update 02/09/19
Ive made the stepper mount shorter as i found the new z mount bracket hit it before the nozzle was just above the bed.
UPDATE 19/08/2019
Found another way of using the standard board. You'll need a donor stepper wire.
https://www.youtube.com/watch?v=yVoJO-2pO9c
Credit goes to TH3D

www.amazon.com/dp/B07DMCT1V9/ref=cm_sw