Thingiverse

Impeller Design 70mm - 3/4/5-Blades

by T__K

47 Downloads

41 Likes

0 Makes

Download Model

3 blatt 3Blade 3blatt 4 blatt 4-blatt 4blade 4blatt 5 blatt 5blade 5blatt impeller impeller jet Impeller pump jet antrieb jet engine motorized impeller water jet 3 blatt 3Blade 3blatt 4 blatt 4-blatt 4blade 4blatt 5 blatt 5blade 5blatt impeller impeller jet Impeller pump jet antrieb jet engine motorized impeller water jet

This is a "remake" i did , by designing the whole thing, from scratch, by myself....as well as using "anti-cavitation" blade- and fin-concepts...
https://www.thingiverse.com/thing:1952400
-> the measurements were taken from his impeller design (at 190percent)

With the center hole , still beeing 8mm in size , as well as a 3x32mm "splinthole" (horizontally of course..) and the outer diameter is 70mm

If you want to use this with the original water-jet-drive ,
you should scale it down to

Source

Thingiverse

Comments