MacBook / Laptop Stand
by TheRubenizer
1
Downloads
1
Likes
0
Makes
I couldn't find a nice stand for my macbook pro, so I designed my own one.
The surface is 23 cm (9") wide by 20 cm (7 7/8") deep. The angle is ±10 degrees.
I printed it in PLA, but ABS or other rigid filaments should work fine too.
If you enjoy the design, please consider leaving a small tip. Thanks :)
*note that on the photo I made a small mistake regarding the hole of the back crossbar. I fixed this in the stil files afterwards. So everything is aligned and symmetrical now.
The surface is 23 cm (9") wide by 20 cm (7 7/8") deep. The angle is ±10 degrees.
I printed it in PLA, but ABS or other rigid filaments should work fine too.
If you enjoy the design, please consider leaving a small tip. Thanks :)
*note that on the photo I made a small mistake regarding the hole of the back crossbar. I fixed this in the stil files afterwards. So everything is aligned and symmetrical now.
Sign in to leave a comment
Sign in