[Titan] [Clone] LCitan (Low Cost titan case) - v1.2.1

Some time ago I did two Pitan (https://www.thingiverse.com/thing:2728600) extruders for my printers. These extruders worked very well, but I wanted know if is possible migrate from a Pitan to a Titan e3d cloned.

So I based my research from this thing https://www.thingiverse.com/thing:1727220

I tried to reuse the most count possible of materials, but nevertheless was necessary buy an aditional bearing to use into the idler.

List of materials:

- 1 x Kit Triangelab Gears for Titan: http