Thingiverse

Printrbot Light Holder

by Wasabi4Alex

18 Downloads

18 Likes

0 Makes

Download Model

2014 3D 3D printing ABS accessory circuit circuit board electronics extruder holder light linear orange printing printrbot regulator simple support voltage

This allow you to place a 6cm diameter halo light underneath the printer so you can see your 3D prints in more detail. This works for the Printrbot Simple 2014 model, but it might work for others. You need supports and it will be hard to remove them, so what I did was I used a dremel to get rid of the supports.
This is where I got the Halo LED Light:
http://www.ebay.com/itm/1Pair-60mm-1210-3528-15LED-Car-Angel-Eyes-Halo-Ring-Light-Headlight-White-Light-/301212933623?pt=Motors_Car_Truck_Part

Source

Thingiverse

Comments