Thingiverse
Skelestruder Omron SS-5GL filament sensor
by kp0005
1
Downloads
0
Likes
0
Makes
THIS IS NOT FOR PRINTERS WITH PRUSA FIRMWARE. I'M USING THIS ON A DUET.
I made this because I wanted a filament sensor and a microswitch seemed a sufficient (and much cheaper) substitute for the Prusa IR sensor. I may make some optimisations in the future to make it a bit smaller but right now there are no clearance issues.
I used this model while making this: https://grabcad.com/library/omron-ss-5gl-limit-switch-1/details?folder_id=1704724
I made this because I wanted a filament sensor and a microswitch seemed a sufficient (and much cheaper) substitute for the Prusa IR sensor. I may make some optimisations in the future to make it a bit smaller but right now there are no clearance issues.
I used this model while making this: https://grabcad.com/library/omron-ss-5gl-limit-switch-1/details?folder_id=1704724
Sign in to leave a comment
Sign in