Thingiverse

3D Pen Mini Spool Mount | SCRIB3D P1 – Bild 1

3D Pen Mini Spool Mount | SCRIB3D P1 – Bild 2

3D Pen Mini Spool Mount | SCRIB3D P1 – Bild 3

3D Pen Mini Spool Mount | SCRIB3D P1 – Bild 4

3D Pen Mini Spool Mount | SCRIB3D P1

von elijahcg314

234 Downloads

557 Likes

0 Makes

Zum Modell

Hardware neaded:
1 x M5x40mm screw
1 x M5 lock nut
2 x Ball Bearing 625 2RS 5x16x5

Installation of spool mount
1. Install the M5 lock nut into spool mount body
2. Screw in the M5x40mm screw into the spool mount body
(the m5 locknut acts as the precision shim for the bearing in the spool to ride against)
3. Install the spool mount to your 3D pen with a twist motion and lock it down with the TPU strap (or rubber band if you don't have TPU).

Putting your mini master spool together.
1. Install the bearings in the spool bodies
2. Add the spool hub (optionable -- i did not install it and it works fine without)
3. Feed a few mm of your filament into one of the 3 holes in spool 2
4. Screw spool 1 and spool 2 together
5. Start winding your mini masterspool to load it up with filament
6. When done loading filament - mount your spool then lock the spool down with the spool lock
7. Turn on the 3D pen and preheat then load the fillament

3D pen spool 3d print 3d print pen 3D printing 3d printing pen 3d spool pen pen spool scrib scrib p1 scrib p1 mod scrib p1 spool scrib3D scrib3d mod scrib3d p1 scrib3d p1 spool scrib3d spool scrib3d spool mod 3D Pen 3d pen art 3d pen creations 3d pen stand 3d pen works filament filament holder filament spool filament spool holder filament-spool spool spool adapter spool holder spool mount spool roller spool stand spoolholder tpu filament 3D pen spool 3d print 3d print pen 3D printing 3d printing pen 3d spool pen pen spool scrib scrib p1 scrib p1 mod scrib p1 spool scrib3D scrib3d mod scrib3d p1 scrib3d p1 spool scrib3d spool scrib3d spool mod 3D Pen 3d pen art

Quelle

Thingiverse

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Einteilig Hardware nötig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker

FDM / FFF

Dateiformat