3D Printable Cruiser Skateboard

SummaryFor bambulabs printer would recommend slicing in half and gluing together with rods in middle IMPORTANT PRINT SETTINGS (for strengthening print and cost of time/filament):Line Perimeters: 10-20Top/Bottom floors: 10-20Extrusion Width: .55-.6 mmLayer Height: .1 - .175 mmInfill: 35-60%Supports: with roof: .05mm air gapABS Temp: 260c, no fanTry to print with at least ABS, or better yet: PC-ABS, Nylon, PC, etcThis skateboard is my newest printing endeavor, after being given access to these monster-sized printers with a large print bed at my work. I designed this to fully take up the width of the print bed, but also included some models that can be printed on smaller printers, but will need to have 12 mm rods (link included below), and CA glue to hold them together.The board holds up to riding pretty well but make sure you follow my aforementioned print settings, that way it will hold your weight. You may hear some crackling sounds when the board is flexed, that's most likely your