3D printable Face Shield

This takes 11 minutes to print, and one minute to assemble. You will need 0.8mm nozzle for this. You can use a 0.4 but it might turn out to be too stretchy. More information will be published as it becomes available here: http://daniepstein.com/daniepstein/3d-printable-face-shield/ Requirements: 1 3D printed band 1 A4 or letter sized OHP transparent plastic sheet or equivalent 3 Staples (ideally use a staple gun) Optionally two sticky foam pads for comfort Staple the OPH sheet horizontally to three locations at the front of the band, as seen in the photos. Add two optional pads for comfort as seen in the photos. That's it. For a clever mash-up check out Maxmilliano Santillan's face shield: https://grabcad.com/library/covidfab-1-5-protector-facial-1