Thingiverse
3D-printable linear actuator
por Bribro12
1.5k
Descargas
1.2k
Likes
0
Makes
Video can be found here: https://www.youtube.com/watch?v=99aw_77oUvY
STL and Editable Fusion 360 source files can be found here: https://bbprojects.technology/collections/stl-fusion-360-source-files/products/3d-printable-linear-actuator-files
This linear actuator is almost completely 3D printed (except for the thread and some bolts, nuts and bearings).I curently don't have any position feedback or limited switches installed on it, I will add them in the feature when I'm going to integrate it in a projecct. It has a speed of about 25 mm/s on a 9V battery and draws about 1.7 Amps of curent. The motor is rated for 36 Volts. Running the linear actuator on a 36 Volt battery will increase the speed of the actuator. The transmission is a belt driven one wich uses a GT2 timing belt and a 3D printed GT2 pulley, This may not be the most ideal transmission for this task but it'll do for some testing. The linear actuator uses an M8 thread to convert the rotating motion into a linear motion.
STL and Editable Fusion 360 source files can be found here: https://bbprojects.technology/collections/stl-fusion-360-source-files/products/3d-printable-linear-actuator-files
This linear actuator is almost completely 3D printed (except for the thread and some bolts, nuts and bearings).I curently don't have any position feedback or limited switches installed on it, I will add them in the feature when I'm going to integrate it in a projecct. It has a speed of about 25 mm/s on a 9V battery and draws about 1.7 Amps of curent. The motor is rated for 36 Volts. Running the linear actuator on a 36 Volt battery will increase the speed of the actuator. The transmission is a belt driven one wich uses a GT2 timing belt and a 3D printed GT2 pulley, This may not be the most ideal transmission for this task but it'll do for some testing. The linear actuator uses an M8 thread to convert the rotating motion into a linear motion.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
