Thingiverse
3D Printable Rose
von joeybechard
144
Downloads
109
Likes
0
Makes
This is a 3D printable rose with a separate base I made for Valentine's Day. This was also a project to determine the capabilities of the Makerbot Digitizer. The base has a pilot hole so you can drill out your own properly sized hole for whatever you want to stick the flower on, or you could just do a boolean subtraction right down the middle of the base in a program like blender. If you drill out a hole, I recommend you do so slowly after you attach the base to the flower.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
