3D Printable SEED_SPROUTER

Welcome,
this a seed sprouter, I realised it because my sister needed it. The sprouts are usually eaten but if have other plans for them... well whatever the heck you want!

Tips to print it:
- Print the support as it is with a decent infill
- Print the grid without bottom and top layers and with a 30-40% grid infill, should be okay for most seeds.

Tips for the use:
1) Place the grid inside the support (from the top) otherwise you won't get far
2) Put some water inside a jar, but not too much, it shouldn't touch seeds
3) Place the sprouter on the jar and place seeds on the grid
4) Spray them with water daily until their roots won't reach water
5) Push the grid from the bottom, cut the sprouts and enjoy your salad ;)


If you will eat a salad with this sprouts please consider to give me a small tip I would be really happy and grateful!