3D Printed Miniature Pinball

Firstly I admit, this is far from perfect. Consider it the begining of a journey that's been fraught with dumb desicions and wrong turns but hey! You got to start somewhere, right? The positives are that it works.The negatives are that if you hit the ball too hard, you will lose the ball, usually high into the air, where it will then do its best to hide from you under the couch. I was aiming for something basic with a simple layout as I wanted to work out the mechanics for the flippers and launcher (not that they can't be improved still) which means when I get around to doing a version 2 it can be more about table design (probably deeper so I can have more paths). I ordered some 10mm ball bearings and they never arrived so I ordered some more locally but they should be here next week. I designed it with 12mm paths for a 10mm ball but had to test with a 8mm ball as it was all I had on hand. The base came around because it works a lot better being tied down, so filling the base with