Thingiverse
3D Printed Side Table (Lack Table)
von DraftingJake
52
Downloads
47
Likes
0
Makes
This is a 3D printed side table. The top is an epoxy top. Any wood top will work and is held with #8 screws. To make the table wider or taller just print more parts as needed. On my printer the parts did not need glue to hold together. In total there was over 165 hours of printing and about 2kg of filament used. Base measures 19.5" x 19.5" x 21.5" You will need the following parts:
4x Side - Mid
8x Side - End
4x Leg - Foot
4x Leg - Middle
4x Leg - Top
4x Side - Mid
8x Side - End
4x Leg - Foot
4x Leg - Middle
4x Leg - Top
DraftingJake veröffentlicht auch auf
6 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!