MyMiniFactory
Workshop & Tools
Zum Modell
3D printed tool hanger
0
Downloads
484
Likes
0
Makes
Designed this modular tool holder to keep my tools (screewdrivers, hex drivers, calipers, pliers, hammer, etc.) organized on my desk. It was designed to be installed on my office, in a 25 mm gap between two wood pannels, without fasteners. I added a backside hole later, so that the modules might also be wall mounted using some screws (actually I didn't test this method). Instructions on how it was designed at https://www.instructables.com/id/3D-Printed-Tool-Hanger/ Did you know you can buy the Anet A8 for only $129.99? Use the coupon code A8KIDA at Gearbest and get it!http://bit.ly/2kqVOdO
igorF2 veröffentlicht auch auf
9 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!