Thingiverse
3D printed tool hanger
von igorF2
1.1k
Downloads
907
Likes
1
Makes
Made this modular tool holder to keep my tools (screewdrivers, hex drivers, calipers, pliers, hammer, etc.) organized on my desk.
It was designed to be installed on my office, in a 25 mm gap between two wood pannels, without fasteners. I added a backside hole later, so that the modules might also be wall mounted using some screws (actually I didn't test this method).
Instructions on how it was designed at https://www.instructables.com/id/3D-Printed-Tool-Hanger/
Did you know you can buy an Anet A8 only $165.99? Get yours at Gearbest:
http://bit.ly/2kqVOdO
It was designed to be installed on my office, in a 25 mm gap between two wood pannels, without fasteners. I added a backside hole later, so that the modules might also be wall mounted using some screws (actually I didn't test this method).
Instructions on how it was designed at https://www.instructables.com/id/3D-Printed-Tool-Hanger/
Did you know you can buy an Anet A8 only $165.99? Get yours at Gearbest:
http://bit.ly/2kqVOdO
igorF2 veröffentlicht auch auf
1 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
