Thingiverse
3D Printed Tool Holders! Tool Rack 2
von DIYTEKNUT
4
Downloads
4
Likes
0
Makes
Designed tool holders using tinkercad https://www.tinkercad.com/
and printed on the anet a2 with 0.8mm nozzle 3 bottom 3 top 1 side layers if using 0.4 nozzle will need 2-3 side layers
printers i own
used the anet a2 3d printer here https://goo.gl/K9h73r
Creality CR-10 https://goo.gl/u2KyRh
TEVO Tarantula https://goo.gl/YWT9sz
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/lD3JDxUXusU
and printed on the anet a2 with 0.8mm nozzle 3 bottom 3 top 1 side layers if using 0.4 nozzle will need 2-3 side layers
printers i own
used the anet a2 3d printer here https://goo.gl/K9h73r
Creality CR-10 https://goo.gl/u2KyRh
TEVO Tarantula https://goo.gl/YWT9sz
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/lD3JDxUXusU
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!