Thingiverse
3D Printed Water Pump
von dat_not_data
12
Downloads
5
Likes
0
Makes
CAD of a water pump that is meant to be 3D printed.
Note that the hole to pass the motor shaft in the casing is too small on purpose and meant to be re-drilled to the smallest possible size that will still allow the motor shaft to pass and rotate freely. Same applies to the hole on the turbine, but a tight fit is desired for the turbine piece.
Note that the hole to pass the motor shaft in the casing is too small on purpose and meant to be re-drilled to the smallest possible size that will still allow the motor shaft to pass and rotate freely. Same applies to the hole on the turbine, but a tight fit is desired for the turbine piece.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!