MakerWorld
3D Printer Accessories
Ver Modelo
3D Printer Cable Shortener
5
Descargas
8
Likes
2
Makes
Do you have lots of unnecessary cable hanging off the back off your printer? This cable shortener was designed to declutter your workspace by getting rid of unnecessary cable. It works by the cable being wrapped around two knobs and a cover being placed on top to conceal it. IMPORTANTPrint the first plate in PETG to make it stronger. How to set upFirst, find out where you want it on you wall and make it level. (make sure it isn't too close to the outlet or the cable won't have room to bend)Take some screws and screw them in through the knobs.Carefully wrap your cable tightly around the knobs.Push the cover on so the middle prongs squeeze through the hole in the center of the case and the ends of the cable fit in the notches built in to the case.Make sure that everything is to your liking and enjoy :)
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
