Thingiverse
3D Printer Enclosure Door Hinge
von kristoforo
205
Downloads
116
Likes
0
Makes
Door hinge for 3D printer enclosure.
It uses M4 bolts.
Overall height is 50mm.
I designed it for 6mm or 1/4" material.
The hinge is snug but not tight. It might come out different for you as your printer and settings might be different from mine. Make sure there are no plastic zits inside the hole of the bottom half and around the pin on the top one to avoid binding.
Happy printing!
It uses M4 bolts.
Overall height is 50mm.
I designed it for 6mm or 1/4" material.
The hinge is snug but not tight. It might come out different for you as your printer and settings might be different from mine. Make sure there are no plastic zits inside the hole of the bottom half and around the pin on the top one to avoid binding.
Happy printing!
kristoforo veröffentlicht auch auf
8 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
