3D Printer Filament Runout Sensor Encloser

I create this case to mount this Filament Runout Sensor I design. You can either use M4 screws to attach the switch, or it can be floating over your extruder. Screw the enclosure together with two (2) M3 x 6mm screws.



This sensor is available for purchase at mini-mods.com.



Instructions on installation and configuration of the sensor and the firmware can be found on this blog post Setup 3D Printer Filament Runout Sensor.



More information about the firmware configuration is available at the official Marlin Documentation found here.


Filament Runout Sensor Demo

[](https://mini-mods.com/wp-content/uploads/2020/01/Filament_Runout_Sensor_Demo.mp4 "3D Printer Filament Runout Sensor Demo")