3D Printer LED light bar adapters

I bought a set of 3 LED light bars from Amazon and wanted to attach them to my CR-10s. I recently added the front braces to the printer and wanted something to add that would possibly attach to the round braces. The magnets would not work because the braces are aluminum themselves and the top "bars" are plastic.

So since these LED's were essentially about a foot long (30cm), but very light weight I figured I could design some adapters to allow me to attach them to the printer frame without too much trouble. There are pressure clips in the kit that can be screwed into a cabinet for mounting these below it. I decided to use these clips for my mounting, but of course there would not be any screwing them anywhere!

I wanted 2 of the LED's mounted to the front braces respectively and the third overhead on the top in front of the "Z" top bar. So, I made the clip strips. These allowed me to place a clip firmly in them and then zip tie them to the round braces. Simple and easy mounting. T