3D printer multimodel test and troubleshooting kit

In the POST-PRINTING section I will tell you what to do with each test after printing is done. PLEASE READ THAT SECTION!

How to print each test:

2x2x2 and 1x1x5 cm blocks: Print them with your normal settings. Use them to test general print quality and dimensional accuracy.

Support Test: Print it with supports enabled so the overhanging piece is supported. Use it to test the quality and strength of support material.

Bridging Test: Print it with supports disabled and bridging enabled. Use it to test the quality of bridging with different lengths.

Stringing Test: Print it with your normal settings. Use it to test for stringing between the posts.

Hollow Box: Print it with your normal settings. Use it to check the quality and strength of infill support as well as how well your printer can handle hollow parts.

Precision Test: Print it with your normal settings. Use it to test the accuracy in increasingly small parts.

DimAcc (Dimensional Accuracy) Test: Print it with