3D Solutech MasterSpool

***UPDATE***

V3 updated with a 54mm diameter opening for those of you with non-stock spool holders. This file has not been tested but I expect it to be similar to V2.

***VERY IMPORTANT***
Be gentile putting the spool together. Further, PLEASE UTILIZE THE LOCKING MECHANISM! There are small holes near the inner circle that are intended for a small piece of filament to go through. This locks your spool together. Without doing this, your spool will be prone to opening up. See photos.

Wasn't able to find a minimalist 3D Solutech Masterspool that I liked, so I decided to remix one. I hope this helps.

Recommendations (not necessary, but helpful):

Material: PETG
Layer height: .2 to .32
Infill: at least 15%
Infill Pattern: Gyroid
Shells: at least 3
Speed: 60 to 80 mm/s

No Supports Needed

I printed a pair in 5hrs 45 min with 85g of material using PETG with 80mm/s, .32 layer height, 3 shells, 15%infill, and Gyroid pattern. This was a fast draft but turned out well. The