Thingiverse
3DLabPrint Hurricane Servo mount
door spinorkit
1
Downloads
1
Likes
0
Makes
Remixed poharatek's excellent design to suit the Hurricane and MG90S or SG90 servos.
Rotated the fairing 180 degrees relative to the base so it would work for the Hurricane and increased its height to provide more protection for the long aileron horns.
Adjusted the servo position to center the horn under the fairing for MG90S and SG90 servos.
Printed the mount in PLA+ (single perimeter, 10% infill).
Printed the cover in LW-PLA (single perimeter, 10% infill)
Rotated the fairing 180 degrees relative to the base so it would work for the Hurricane and increased its height to provide more protection for the long aileron horns.
Adjusted the servo position to center the horn under the fairing for MG90S and SG90 servos.
Printed the mount in PLA+ (single perimeter, 10% infill).
Printed the cover in LW-PLA (single perimeter, 10% infill)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!