3DLabPrint Spitfire XVI Accessories

Here a some accessories for the 3DLabPrint Spitfire XVI.

Firstly is a Battery and balance weight holder. There are two versions depending on the thickness of your Lipo.

* SpifireBatteryHolder1.STL - Thinner and lighter Lipos so more space for balance weight.
* SpifireBatteryHolder2.STL - Thicker and heavier Lipo with less balance weight capacity. It can take up to a Turnigy Graphene 2200mAh 65C.

Depending on the length of your Lipo you might want some longer battery clips.

* SpitfireBatteryClip6.STL - This clip is 6mm longer than the standard one.
* SpitfireBatteryClip10.STL - This one is 10mm longer.

To help keep the weight as far forward as possible I designed a clip (SpitfireESCRetainer.STL) to hold the ESC as far forward as the reciever cable and space would allow.

Finally its second landing the tail broke off at the glue joint behind the cockpit. To prevent this I designed a joint doubler (Spitfire_XVI_fuselage_5-Bulkhead.STL) to increase the glue area and