3DR Solo Payload Release Bait Drop

This is a Payload Release using a 9G servo. For the pull pin I use a short piece of plastic wire tie and curve it slightly.

Fits with a small breakout board like this one from Brownie Boards
https://store.brownieboards.com/product/3dr-solo-nano-breakout-board/

Wire path underneath can also conceal a female-male connection so if you solder in a connector and run it out to the mechanism it will snap into the slot underneath making it easy to remove and install if needed.

Information for how to solder and connect the wiring can be found here: https://www.hackster.io/phantom-phreak-7ccfe4/extend-3dr-solo-accessory-bay-be4073