3DS Masterspool Minimal V2

Updated version of my 3DS Masterspool Minimal spool, designed to work with 3D Solutech's Masterspool. This spool works much better with filament rewinders as it prevents the filament from getting tangled in the side arms. This spool uses about 26m of filament and can be printed in less than 8 hours depending on settings. I have also added a version of part 1 that has space for a label.

To load place the part 1 side, without the three center holes, on a surface. Place masterspool on part 1 so center splines are inside of cardboard hub. Place part 2 so center splines are aligned with splines on part 1 and part 1 splines pass through the holes in part 2. Both sides will snap together and then you can cut the wire ties holding the filament together.