Slicer Discord
3inch Aeroring X – Modelo 3D imprimible de MakerWorld MakerWorld
RC

3inch Aeroring X

por Aerobot2 · RC
41 Descargas
12 Likes
10 Makes
Ver Modelo
The Aeroring was designed to be flown as a PLUS, however recent trends and YouTubers suggest that the X configuration is better!!So the Model has also been designed as an X. Here is one simple example. Imagine the drone is cruising along at an angle of 45 degrees, 100 kilometers per hour, then you initiate a full 360-degree right roll. Here’s what happens:In a Plus frame, only the right motor slows down, and the left motor speeds up to create the roll, while the front and rear motors maintain consistent thrust. This balance ensures the drone retains altitude throughout the maneuver. Perfect for doing (flippyfloppys) acro flying!!Now compare that to an X frame. During the same 360-degree roll, two motors on one side slow down, and two on the other side speed up. Which leads to altitude loss. To combat this they are relying on more authority of the two motors that speed up and some snappy rates with higher PID's for the Roll Axis. This is not natural and is band aiding your flying st
Categoría
RC
Fuente
MakerWorld
Publicado
Actualizado
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección