Thingiverse
3inches
di AuxPlumes
0
Download
1
Likes
0
Makes
Dumping this here : p
IMPORTANT NOTES
- TPUs are made for Ø4 mm M2 standoffs, either with a length of 15mm or 20mm
- Prints are made for a whip antenna Ø5mm - If you need it smaller, just ask and I'll do it for you
- The fpv camera mount is made for the Baby ratel - but works with similar sized camera ( short )
- This build is made for 3S with 1404 motors - Be careful with the size of the LiPo : 25mm of width maximum, or it could clip the props ( GNB 3S 720Mah HV are perfect )
- I've put a .step file for the Carbon and some TPUs to modify it easily if needed
IMPORTANT NOTES
- TPUs are made for Ø4 mm M2 standoffs, either with a length of 15mm or 20mm
- Prints are made for a whip antenna Ø5mm - If you need it smaller, just ask and I'll do it for you
- The fpv camera mount is made for the Baby ratel - but works with similar sized camera ( short )
- This build is made for 3S with 1404 motors - Be careful with the size of the LiPo : 25mm of width maximum, or it could clip the props ( GNB 3S 720Mah HV are perfect )
- I've put a .step file for the Carbon and some TPUs to modify it easily if needed
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
