Thingiverse
3kg spool-holder
by EUCGUY
5
Downloads
10
Likes
0
Makes
A custom spoolholder for 3kg spools.
The square holes at the bottom part are 1mm from the bottom layer. This is for magnets that are 10x10. Same goes for the walls that holds the bearings. Magnets.
Print,glue and insert bearings.
Bearing used: Outer D:52mm. Inner D:24,95mm Widh D:15mm
Spool hole D:29.920 mm
The square holes at the bottom part are 1mm from the bottom layer. This is for magnets that are 10x10. Same goes for the walls that holds the bearings. Magnets.
Print,glue and insert bearings.
Bearing used: Outer D:52mm. Inner D:24,95mm Widh D:15mm
Spool hole D:29.920 mm
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
