3ml Vial Snap Lock Remix

This is a remix of @Hugo 's snap lock v3. I am new to the 3d modeling and using tinker cad so the stl looks a little rough but it prints clean. This will hold 10 3m vials. I squared the base, added holes for the vials and shortened the top so that the vials will stay in place better if it gets turned upside down while closed. I also altered it to have one snap as two seemed a bit much for this short of a box. I printed using PLA+ with .2 Layer and 4 walls to give the hinges some strength when snapping it together. For instructions on putting the box together please see @Hugo snapv3 post. After putting a few together i have found that if I begin to insert the lid in the ridges on the hinge, apply a little force, and wiggle I have an easier time getting it together.