Thingiverse
3mm Drill Bit Handle
door Alzibiff
49
Downloads
35
Likes
1
Makes
Customized version of http://www.thingiverse.com/thing:91035
Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=91035
It has just occurred to me that you could either make several of these to accommodate single drill bits or make two or three with each one capable of taking three or four sizes if you use long enough grub screws and are prepared to swop the drill bits as and when needed.
EDIT
Tried my 8mm version with some different sized drill bits and found that the range of sizes which you can fit securely is not that large - will print some more and use one drill bit per handle. (Total filament with 15% infill is only around 2m anyway).
Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=91035
It has just occurred to me that you could either make several of these to accommodate single drill bits or make two or three with each one capable of taking three or four sizes if you use long enough grub screws and are prepared to swop the drill bits as and when needed.
EDIT
Tried my 8mm version with some different sized drill bits and found that the range of sizes which you can fit securely is not that large - will print some more and use one drill bit per handle. (Total filament with 15% infill is only around 2m anyway).
Alzibiff publiceert ook op
65 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
