Thingiverse
4 Channel Ethernet Audio Snake
von Precords
0
Downloads
0
Likes
0
Makes
What you'll need is:
4x D series panel mount audio jacks of your choice (XLR, TS, TRS)
1x D Series RJ45 connector
Some cat 5/6 cable
Wire up a cat5 cable with shared pin 1/ground across your audio connectors, you will have enough other wires to do pins 2+3 on your 4 audio connectors and then make sure you do that same wiring on the opposite end (as you need 2 of these - one at each end)
*Caution* - not for speaker wires! No Speakon, Powercon - signal wires only
I will add more updates to the main housing in the coming future, including a shorter one so you could have it go direct to a tail-whip, or connect with the RJ45 inserts you can buy at your local home depot.
Once wired up and verified working, I recommend gluing the box shut with silicone, you can cut it open easily.
4x D series panel mount audio jacks of your choice (XLR, TS, TRS)
1x D Series RJ45 connector
Some cat 5/6 cable
Wire up a cat5 cable with shared pin 1/ground across your audio connectors, you will have enough other wires to do pins 2+3 on your 4 audio connectors and then make sure you do that same wiring on the opposite end (as you need 2 of these - one at each end)
*Caution* - not for speaker wires! No Speakon, Powercon - signal wires only
I will add more updates to the main housing in the coming future, including a shorter one so you could have it go direct to a tail-whip, or connect with the RJ45 inserts you can buy at your local home depot.
Once wired up and verified working, I recommend gluing the box shut with silicone, you can cut it open easily.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
