Thingiverse
4" Dust Hose Mount
door Maxxra
12
Downloads
2
Likes
0
Makes
To be used with 4" worm gear clamp (assumed to be .5" wide).
Directions: Unscrew clamp via worm gear until apart. Pass through the center of the mount and re-attach the clamp. Screw mount into wall (I use 2" woodscrews with washers) and tighten the worm gear.
Printed on Lulzbot Taz5 & Mini without struts or supports (overhang seems to hold nicely) with PLA. Layer height apx .20
Works well with t-joints and dust gates too.
Directions: Unscrew clamp via worm gear until apart. Pass through the center of the mount and re-attach the clamp. Screw mount into wall (I use 2" woodscrews with washers) and tighten the worm gear.
Printed on Lulzbot Taz5 & Mini without struts or supports (overhang seems to hold nicely) with PLA. Layer height apx .20
Works well with t-joints and dust gates too.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
