4 Gear Fidget

Why have 2 gears when you can have 4? I borrowed some of the parts from the original geared keychain because they were just designed perfectly. Not sure if this counts as a remix being its double the original and I had to design new face plates.

https://www.thingiverse.com/thing:1805812

Printed the faceplates and clips at 100% infill, The rest was printed at 30%

Printed parts needed:
Gear 1 X 2
Gear 2 X 2
Axel X 4
Clip X 4
Faceplate X 2

Assembly Instructions:

1. Put 4 Axles through 1 faceplate and lay on flat surface with axles grooved side pointing up and faceplate on the flat surface

2. Arrange the 4 gears so the teeth lock into each other and form an outside square shape.

3. Put the "gear square" over the 4 axles with 1 axle going into the center of each gear in their respected corners.

4. Put last faceplate on top of the axles and gears with the axles popping through the faceplate.

5. Slide a clip around the top of each axle in the grove area t