4 inch Frame assembly

4 inch frame designed for 1404 motors on 6S Lithium 18350

The frame is strapless as it uses DIY 18350 battery 6S that slides on a bottom track and can be secured with paper clip slid into pin hole from the sides.

Battery case should be printed with TPU
Bottom track works best printed in TPU as well.
Top Plate comes with DJI Mount holes and Beeper with easy click off. Best printed with PLA + . Top plate can also be carbon but I use PLA to orevent CF from blocking radio signal on Long Range flights.
The cam mount I use is from Diatone 4 inch
Frame it's self has all holes needed for any config.

Please let me know if you have nice solution for cam mount.

NOTE: The frame should be fabricated out of Carbon Fiber and NOT 3D printed.