Thingiverse
4-Line Mini-dryer Stand
di mattpederson
4
Download
3
Likes
0
Makes
Wife needed a mini dryer stand to paint the edges pass-holder tabs that she was making for an upcoming Comicon.
Will need to print two of each part.
The cross bars are a tight fit inside the end piece sockets. Don't use too much compressive force...may need a little sanding, especially if you want to take it back apart again to minimize storage space.
Cross bar dimensions are 200mm long, 9.2mm wide, 15.2mm tall
Tab edge dryer rack end piece dimensions (when standing) are180mm tall, 140mm wide, max 30 mm deep. Socket internal dimensions are 10mm by 16 mm by 20 mm deep.
Use some paracord as the lines between the end pieces and appropriate clips to attach whatever you need to dry.
Will need to print two of each part.
The cross bars are a tight fit inside the end piece sockets. Don't use too much compressive force...may need a little sanding, especially if you want to take it back apart again to minimize storage space.
Cross bar dimensions are 200mm long, 9.2mm wide, 15.2mm tall
Tab edge dryer rack end piece dimensions (when standing) are180mm tall, 140mm wide, max 30 mm deep. Socket internal dimensions are 10mm by 16 mm by 20 mm deep.
Use some paracord as the lines between the end pieces and appropriate clips to attach whatever you need to dry.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
