4 -to- 1 PTFE Module

by ProtoSpyre3D · 3D Printer Accessories

1.3k Downloads

487 Likes

756 Makes

🚀 PROTOSPYRE's 4 -to- 1 PTFE Module🌟 INTRODUCTION ~ ~ ~FYI Due to each users printing setup there is absolutely zero guarantees this model will work/operate for everyone the same - For Optimal Results; Please ensure filament used for this model is dried! We highly encourage using PLA PRO! - We listen to everyone's feedback and respond with full compassion. Most negative feedback is due to lack of feeding smooth & stoppages - We remind you to please ensure the feeding holes are absolutely clear and unobstructed prior to assembly & use. We encourage everyone to also test the device using filament changes on a small test model so you can listen and see if any resistance is shown within the module. <p sty