RMRC RDQ Rotor Riot PSU Covers
by WoodyInMD
12
Downloads
11
Likes
1
Makes
Covers for the 24V/400W power supply unit sold by numerous outlets for RC battery chargers.
These are a friction fit for both ends of the power supply (mains/120v and 24V).
For the XT60 end:
- print on the connector end with no supports.
- the fit can be a little tight between the wall of the charger and the connector block. If the connector twists out of position slightly it can block the cover from sliding into place. Do not force the cover in place but ensure there is adequate clearan
These are a friction fit for both ends of the power supply (mains/120v and 24V).
For the XT60 end:
- print on the connector end with no supports.
- the fit can be a little tight between the wall of the charger and the connector block. If the connector twists out of position slightly it can block the cover from sliding into place. Do not force the cover in place but ensure there is adequate clearan
Sign in to leave a comment
Sign in