4040 motor bracket

This bracket enables a nema 17 59mm to be fitted onto 4040 extrusion for dual z vertical motion. The reason for this is to move the vertical rails from the sides and house them between the rails so that you will gain a little extra width for the heat bed left and right but lose a little height. The groove on one side allows the wiring to be directed into the 4040 extrusion for a neater install. If you print this is PLA you will need a low amp motor as the heat will melt it, PETG would be better. the design is off centered because the motor is 42x42 the rail 40x40 this allows a flush outside fit if you wish to box in your printer