Thingiverse
4040 Mount for StreamDeck XL
by PaxUX
50
Downloads
33
Likes
0
Makes
Built for my own Simpit, but others might find it useful. Images are in the orientation I printed out each object. Hinge Arms Long or Short can be printed, I use the long version. A total of 3 is required to attach to the Deck Hinge.
Only the 4040Connection piece requires support, just the curved section touching the base. The Angled slope is printable without support just make sure the angle is set to 47 or greater. Also the fit is tight enough it doesn't need to be bolted into place.
Printed with Cura using ZipZag fill of 15%. M4 blots would be best, but I went with M5 that slightly cut into the plastic to hold the joints in place.
This a more a kitbase of Mount Anything and StreamDeck XL object. Couldn't find the original project on this site.
Only the 4040Connection piece requires support, just the curved section touching the base. The Angled slope is printable without support just make sure the angle is set to 47 or greater. Also the fit is tight enough it doesn't need to be bolted into place.
Printed with Cura using ZipZag fill of 15%. M4 blots would be best, but I went with M5 that slightly cut into the plastic to hold the joints in place.
This a more a kitbase of Mount Anything and StreamDeck XL object. Couldn't find the original project on this site.
PaxUX also publishes on
1 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
