RepRap Protos V3 BallBearing Z-Axis mount

this is a Z-Axis mount for one side. need to mirrored for the oposite site.

#will be updated later, when print and tests are done...
this is a Z-Axis mount for one side. need to mirrored for the oposite site.
M8 Rods for Z-Axis need to be replaced cause they are to short to be fixed on this part ;)
#will be updated later, when print and tests are done...

further you need:
- 2 M6 hex nuts and some washers
- M6 screws
- Ballbearing 608Z
- 4 M3 hex nuts
- 4 M3 screws
per side ;)