TAS-Wanhaoi3Plus-Hemera_Adapter
7
Downloads
3
Likes
1
Makes
This is my 1st attempt at creating an adapter for the E3D Hemera Extruder to fit the Wanhao i3Plus.
Credits: < To Be Added>
ATTENTION: Since the x-belt clamp connects to the lower length of the loop, you will need to reverse the direction of the x-stepper in firmware or swap the center two wires on the plug.
Note: the holes for the x-axis limit switch are too far apart. I just have not had time to change that in the design.
Future Versions:
v1.5 - Add wire clips, mesh modifiers for s
Credits: < To Be Added>
ATTENTION: Since the x-belt clamp connects to the lower length of the loop, you will need to reverse the direction of the x-stepper in firmware or swap the center two wires on the plug.
Note: the holes for the x-axis limit switch are too far apart. I just have not had time to change that in the design.
Future Versions:
v1.5 - Add wire clips, mesh modifiers for s
Sign in to leave a comment
Sign in