Fractal Christmas tree
by PalRas
0
Downloads
0
Likes
0
Makes
Fractal Christmas tree
Having made this fractal figure, I thought that it - with a little good will and Christmas mood - might well resemble a Christmas tree !?
No support used, but in Cura 4.4.0 I found an Experimental feature called "Make Overhang Printable". I have enabled the function and applied the value 41 ° for "Maximum Model Angle".
I also used the "Enable Ironing" feature.
Merry Christmas (This was written on December 25, 2019)
Having made this fractal figure, I thought that it - with a little good will and Christmas mood - might well resemble a Christmas tree !?
No support used, but in Cura 4.4.0 I found an Experimental feature called "Make Overhang Printable". I have enabled the function and applied the value 41 ° for "Maximum Model Angle".
I also used the "Enable Ironing" feature.
Merry Christmas (This was written on December 25, 2019)
Sign in to leave a comment
Sign in