Motor Phase Wire Grommet for 17mm Dia wire

I needed custom grommet to route the 17mm OD phase wires from the motor, to the controller, through the bulkhead on our ~1000 hp electric land speed vehicle, the Green Envy. There are four Cascadia PM100 controllers powering two AVID AF240 motor (with two stators each) which mean four sets of three 50mm2 coaxial phase leads for each. These need to be sealed where they pass through the bottom of the bulkhead to keep the salt and dust out of the delicate electronics.

I printed these on my Lulzb