Ender 5 BLTouch (3mm lower) + Hot End Wire Strain Relief Bracket

I wanted to combine a Hot End Strain Relief bracket (https://www.thingiverse.com/thing:3937920) and a BL Touch 3mm Lower Bracket (https://www.thingiverse.com/thing:3388571/), and found that one had already been created.
(https://www.thingiverse.com/thing:3715939)

When i printed it however, it didn't line up with the screw holes. I found the join between the brackets to be a bit weak and my factory screws for the hot end wouldn't fit in the recessed holes and one was too short. So using Timca